Getting Started
Take some simple measurements to determine the perimeter dimensions of your new fence.
Use graphing paper to sketch out your fence design on paper, as a visual aid.
Calculate how many Standard Width (73”) fence panels, and fence posts (3.5”) you’ll need to span the fence perimeter.
If you choose to add Gate Panels or Custom Width Panels, make sure to include these measurements into your overall design.
Installation
Disclaimer: Eden Fence Co. sells fence products. We do not offer fence installation services. We guarantee the quality of the products we sell, but we cannot guarantee the quality of any specific fence design or installation. We leave the fence building up to you.
If you need assistance installing your fence, please reach out to a friend, family member, or professional contractor. Every fence project is different, and every person has a different skill level. Please build at your own risk and take the proper safety precautions.
Materials
Set out your fence building materials and tools. Double check to make sure you have everything needed to get started.
Perimeter Layout
Use a measuring tape and string-line to accurately mark out the fence perimeter.
Post Hole Layout
Use a measuring tape and spray-paint to mark the exact location where you’ll dig the post holes. Pay special attention to ensure the spacing is accurate.
Dig Post Holes
Dig the post holes 18-24” deep and 12” in diameter. This will allow some wiggle-room later on, if needed. Remove all loose soil from the hole, and set it aside.
Set Corner Posts
Set your corner posts first. Ensure they are accurately spaced, level, and firmly installed into the ground.
Use a String-Line
Attach a string-line, flush (and tight) across the top of your corner posts, spanning the entire fence perimeter. This way, when you place each additional post, you can ensure that the post is at the correct height.
Using a string-line in this way, is especially helpful if the ground under your fence perimeter is uneven.
Check Measurements
Once all posts are set into their post holes, start from one of your corner posts, and double check to ensure that the posts are spaced correctly, level and lined up with the string-lines.
Pay special attention to any gate openings, to ensure that the gates will have proper clearance once installed.
Add Soil
Lightly pack soil around each fence post, to help hold them in the correct position.
Clamp Fence Panel
With help from a friend, lift your first fence panel into place, between two fence posts. We recommend placing panels closest to any gate openings first. Each fence panel should fit snugly between the posts. With the panel held in the correct place, use a Clamp Tool to firmly clamp the panel to its post (on both sides).
Attach Fence Panel
With the panel clamped in the correct position, it’s time to permanently mount the fence panel. Locate the eight pre-drilled mounting holes on the fence panel. Using the provided 6” hex-head screws, screw the panel into the posts. Do not over-tighten. (Repeat until all fence panels are installed)
Pack Posts
Firmly pack remaining soil around every fence post. Ensure that all posts are solidly embedded into the ground. Discard any leftover soil.
Position Gate(s)
With help from a friend, lift the gate panel in place, between the gate-opening posts. Use the provided gate-spacers to create a 1/2” gap between the hinge-side of the gate panel and its post. With the spacer in place, clamp the hinge-side of the gate panel to the post, at both the top and bottom.
Attach the Gate(s)
Using the provided hardware, screw the gate hinges firmly into the post.
On the opposite side of the gate panel, mark where the the gate latch locking-bar touches the post. Carefully place the gate latch receptacle in-line with the locking bar, and screw it in, using the provided hardware.
Enjoy your Fence!
Step back and marvel at the beautiful fence you’ve just created!